V L - A 1 1 0 U / p p . 0 0 7 - 0 1 7 ; 0 0 / 1 1 / 2 1 / 1 8 : 0 0
G. K . A s s o c i a t e s , To k y o
7
Preparation
Preparation
Inserting and Removing the
Battery Pack
Inserting the Battery Pack
1
Make sure that the Power switch is set
to OFF.
2
Slide the battery compartment door
release on the bottom of the VIEWCAM
in the direction of the arrow to open the
battery compartment door.
3
Insert the battery pack into the com-
partment as shown, and push it in com-
pletely until it locks into place.
Caution:
• Do not force the battery pack into the
battery compartment if it does not go in
easily.
Removing the Battery Pack
1
Perform steps 1 and 2 above.
2
Press the battery release as shown to
remove the battery pack.
Preparation
Preparation
Cautions:
•
BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP THE TAPE AND TURN THE
POWER OFF.
If you remove the battery pack
during recording or playback, the tape will
remain wound around the video head drum,
potentially causing damage to the tape.
• Make sure the battery compartment door is
closed firmly during operation. If it is not, the
battery pack may fall out or VIEWCAM operation
may fail because of the poor contact pressure.
• Remove the battery pack from the VIEWCAM if
the VIEWCAM will not be used for a long period
of time.
•
When removing the battery pack, do not tilt
the VIEWCAM so that the battery compart-
ment faces down. The battery pack may fall
out.
• Do not expose the battery compartment door to
strong force, as it may come off.
• Use only SHARP model BT-H22 or BT-H32
battery packs with this VIEWCAM. Use of other
batteries may present a risk of fire or explosion.
Power switch
4
Close the door, pressing it firmly in the
center until it clicks.
Battery release
Battery
compartment
door release
Summary of Contents for VIEWCAM VL-A110U
Page 72: ......