E-13
ENGLISH
WF-1100W
2008/November/6
WF-1100W_MK2-EN
MK2
Advanced Feature
Enhancing your system (continued)
AUX IN
To listen to or record signals from external units such as CD players.
Notes:
To prevent noise and interference when using the tuner, turn off
the power to your CD player.
To prevent hum interference, do not place this unit near television
receivers.
Mixing from a microphone and TAPE
To listen to or record mixed signals from an external microphone and
TAPE 2.
Notes:
Place the microphone about 10 - 15 cm (4 - 6") away from the
source.
If howling occurs, lower the volume or move the microphone as far
as possible from the speaker.
To record the microphone signals only, load a cassette into the
TAPE 1 cassette compartment, set the FUNCTION switch to
TAPE and the DUBBING SPEED switch to NORMAL. Then, press
the RECORD button.
Caution:
When not using the microphone, remove the microphone plug.
1
Use an RCA lead to connect the desired external unit to the
AUX IN sockets.
(red
→
→
→
→
right channel, white
→
→
→
→
left channel)
2
Set the FUNCTION switch to AUX.
3
Operate the CD player or other external unit.
4
To record the sound from the external unit, perform steps
2 - 5 of the “Recording from the radio” section on page 11.
MIX MIC
PLAY
RECORD
DUBBING
SPEED
VOLUME
FUNCTION
1
To protect the speakers from shock noise and to avoid
disturbing noises, set the VOLUME control to minimum.
Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance: if not, use an
appropriate adaptor.
2
Connect the microphone plug to the MIX MIC socket.
3
Set the FUNCTION switch to TAPE.
4
Set the DUBBING SPEED switch to NORMAL.
Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH or MIC.
5
Load a blank tape into the TAPE 1 cassette compartment
for recording or insert a pre-recorded cassette into the
TAPE 2 cassette compartment.
6
Adjust the volume of the audio source and the microphone
using the VOLUME control.
7
For mixing playback, press the PLAY button of TAPE 2. For
mixing recording, press the PLAY button of TAPE 2 and
RECORD button of TAPE 1.
