Sharp WF-5000W, Operation Manual

E-18

06/2/24

WF-5000W(U)3.fm

TINSEA095AWZZ

ENGLISH

WF-5000W

Advanced Features

Timer playback or timer recording

Before setting timer:

Note:

1 Check that the clock is set to the correct time (refer to page 11).

If it is not set, you cannot use the timer function.

2 For timer playback:

Load a cassette to be played.

For timer recording:

Load a cassette for recording in the cassette
compartment.

1

Press the ON/STAND-BY button to turn the power on.

2

Press the CLOCK/TIMER button.

3

Within 10 seconds, press the 

 or 

 button to select "ONCE" or

"DAILY", and press the MEMORY button. 

Set the unit to the correct time if "ONCE" or "DAILY" does not appear.

4

Within 10 seconds, press the  

or  

button to select "ONCE

SET" or "DAILY SET", and press the MEMORY button. 

5

Press the  

or  

button to select "PLAY" or "REC", and press the

MEMORY button.

The illustrations show the daily timer setting.

6

Press the  

or  

button to adjust the hour and then press the

MEMORY button.

The illustrations show the timer playback setting in the daily timer mode.

7

Press the  

or  

button to adjust the minutes and then press the

MEMORY button.

8

Set the time to finish as in steps 6 and 7 above.

White

Red

9

  Switch input with the  

or  

button, and then press the 

 MEMORY button.

To select the timer playback source: TUNER, TAPE 1, TAPE 2 or CD/
LINE.
To select the timer recording source: TUNER or CD/LINE.

When you select the tuner, select a station by pressing the

or

button, and then press the MEMORY button.

If a station has not been programmed, "NO P.SET" will be
displayed and timer setting will be cancelled.

10

Adjust the volume using the VOLUME control, and then press the
MEMORY button.

Do not turn the volume up too high.

11

  Press the ON/STAND-BY button to enter the power stand-by 
  mode.

The "TIMER" indicator lights up and the unit is ready for timer playback
or timer recording.

12

  When the preset time is reached, playback or recording will start.

The volume will increase gradually until it reaches the preset volume.

13

  When the timer end time is reached, the system will enter the

power stand-by mode automatically.

Once timer:

The timer will be cancelled.

Daily timer:

The timer will operate at the same time every day. It will continue until
the daily timer setting is cancelled. Cancel the daily timer when it is
not used.

When performing timer playback or recording using another unit connected to
the CD/LINE sockets, select "CD/LINE" in step 9.
This unit will turn on or enter the power stand-by mode automatically, how-
ever, the connected unit will not turn on or off.