2
Using the Organizer for the First Time
Be sure to perform the following operations before using the Organizer
for the first time.
1. Pull out the battery insulation sheets
from the battery compartment on the
back of the unit.
The Organizer starts operation.
(The battery insulation sheets were
inserted at the factory to prevent
battery wear.)
2. Press the
RESET
switch.
A message, “RESET?” is displayed.
3. Tap
f
, then
x
.
To tap the touch keys, use the stylus (included in the package).
The message will appear as “RESET!”.
The Organizer is now initialized. Proceed to set the date and time of
the clock (see page 6).
Note:
• Press the
RESET
switch using the stylus or similar object.
Do not use an object with a breakable or sharp tip.
If a malfunction occurs under abnormal conditions
If the Organizer is subjected to strong extraneous electrical noise or
shock during use, on rare occasions, all the functions will not work
properly and data may be displayed incorrectly. In such cases, follow
the procedures as shown below.
1. Press the
RESET
switch.
2. When a message, "RESET?" is displayed, press any key EXCEPT
FOR
f
or
x
.
If the first procedure doesn't work, follow the next procedure to
initialize the Organizer's memory. In this case, all the stored data will
be deleted.
1. Press the
RESET
switch.
2. When a message, "RESET?" is displayed, tap
f
, then press
x
.
RE
SE
T
RESET
OZ-290HII(En).pm65
05.2.2, 3:53 PM
2
Summary of Contents for Wizard OZ-290HII
Page 76: ...MEMO ...
Page 77: ...MEMO ...
Page 78: ...MEMO ...
Page 80: ...SHARP ELECTRONICS CORPORATION Sharp Plaza Mahwah New Jersey 07430 1163 ...