05/7/12
XL-DAB9H(H)E3.fm
E-27
ENGLISH
TINSZA071SJZZ
XL-DAB9H
FM O
p
eration
Listening to the memorised FM station
Memorising a station
You can store 40 FM stations in memory and recall them at the push
of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead discon-
nection.
To recall a memorised station
Move the operation lever toward PRESET or PRESET for less
than 0.5 seconds to select the desired station.
To select a preset station with the direct number buttons:
Press the corresponding number ("0" - "+10").
Example:
To select 28, press "+10", "+10" and "8".
To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
To clear a memorised station
To erase entire preset memory
1
Perform steps 1 - 3 in "Listening to the FM" on page 26.
2
Press the MEMORY/SET button to enter
the preset tuning saving mode.
3
Within 5 seconds, move the operation le-
ver toward PRESET or PRESET to se-
lect the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the MEMORY/
SET button to store that station in memo-
ry.
If the "Memory" and preset number indicators go out before the
station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
1
Move the operation lever toward PRESET or PRESET for
more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2
Move the operation lever toward PRESET or PRESET again
when the desired station is located.
1
Recall the memorised station.
2
Whilst it is displayed, press the MEMORY/SET button.
3
Within 5 seconds, press the CLEAR button.
1
Press the ON/STAND-BY button to enter the power stand-by
mode.
2
Whilst pressing down the MEMORY/SET button and move the
operation lever toward PRESET , press the ON/STAND-BY
button until "Preset Clear" appears.
Downloaded from:
