04/1/28
XL-DH10N 20H_001 EN
E-14
9
8
7
6
5
4
3
2
1
9
Listening to the radio
Notes:
●
When radio interference occurs, auto scan tuning may
stop automatically at that point.
●
Auto scan tuning will skip weak signal stations.
To receive an FM stereo transmission:
●
Press the TUNER (BAND) button to select stereo mode
and “ST” indicator will be displayed. “
” will appear
when an FM broadcast is in stereo.
●
If the FM reception is weak, press the TUNER (BAND)
button to extinguish the “ST” indicator. The reception
changes to monaural, and the sound becomes clearer.
You can store 40 AM and FM stations in memory and recall
them at the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
Press the PRESET (
or
) button for less than 0.5
seconds to select the desired station.
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
■
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select
the desired frequency band (FM or AM).
3
Press the TUNING (
or
) button on the remote
control to tune in to the desired station.
●
Manual tuning:
Press the TUNING (
or
) button repeatedly to
tune in to the desired station.
●
Auto tuning:
When the TUNING (
or
) button is pressed for
more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first
receivable broadcast station.
CD
USB
MUTE
MUTE
CLOCK/TIMER
CLOCK/TIMER
TUNING/
FOLDER
AUX
AUX
PTY
PTY
RDS
RDS
■
Memorising a station
1
Perform steps 1 - 3 in “Tuning”.
2
Press the MEMORY button.
3
Within 5 seconds, press the
or
button to select
the preset channel number. Store the stations in
memory, in order, starting with preset channel 1.
4
Press the MEMORY button to store that station in
memory. If the “MEMORY” and preset number
indicators disappear before the station is memorised,
repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
■
To recall a memorised station
■
To scan the preset stations
1
Press the PRESET (
or
) button for more than 0.5
seconds. The preset number will flash and the
programmed stations will be tuned in sequentially, for 5
seconds each.
2
Press the PRESET (
or
) button again when the
desired station is located.
■
To erase entire preset memory
1
Press and hold the CLEAR button until “CLR MEM”
appears.
Summary of Contents for XL-DH10NH
Page 32: ...92L410CM903011 097 R AS 1 ...
