XL-DH330PH_09 EN.fm
E-7
20/07/10
Listening to the iPod or iPhone (continued)
Notes:
●
Please use the adaptor supplied with your iPod or iPhone
unit.
●
You can use an audio cable to connect your iPod to the
AUDIO IN socket if:
1.
your iPod adaptor does not fit into the iPod dock on the
main unit.
2.
you have an iPod that does not have an iPod adaptor.
3.
you have an iPod that does not have an iPod 30 pin
connector.
Caution:
Unplug all accessories from the iPod or iPhone before
inserting it into the dock.
●
Sound will only switch from iPhone to the main unit after
authentication process is completed in approximately 10
seconds.
●
Incoming calls will pause the playback and iPhone ringtones
will be heard from the main unit speakers only.
●
Once the calls are answered, the conversation can only be
heard through the built-in iPhone speaker. Turn on the iPhone
speaker or undock the iPhone to start conversation.
Simply remove the iPod or iPhone from the iPod dock. It is safe to
do so even during playback.
Note:
When navigating the iPod or iPhone menu with remote control, do
not operate any of the buttons on the iPod or iPhone unit. The
volume level is adjusted by pressing the VOL (+ or –) button on
the main unit or the remote control. Adjusting the volume on the
iPod and iPhone units give no effect.
iPod and iPhone operations:
The operations described below depend on the generation iPod
and iPhone you are using.
System on operation:
When the main unit is powered on, the iPod and iPhone units will
automatically power on when docked in the unit.
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked iPod
and iPhone unit will automatically turn to stand-by mode.
■
iPod and iPhone adaptor connection
iPhone
Adaptor No.
iPhone
Description
Capacity
12
iPhone
4GB & 8GB & 16GB
15
iPhone 3G
8GB & 16GB
15
iPhone 3GS
16GB & 32GB
■
To insert iPod or iPhone adaptor
1
Open the iPod cover by pulling up the tip.
2
Insert the iPod or iPhone adaptor into unit and connect
your iPod or iPhone.
■
To remove iPod or iPhone adaptor
Insert the tip of a screwdriver (“–” type,
small) into the adaptor hole as shown and
lift upward to remove.
■
iPod or iPhone playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod/iPhone button on the remote control or
FUNCTION button repeatedly on the main unit to select
iPod function.
3
Insert iPod or iPhone unit in iPod dock of main unit.
4
Press the / (iPod/iPhone / ) button to start
playback.
iPhone
Dock connector
iPhone (bottom)
iPhone dock
iPhone connector
iPhone adaptor
■
iPhone playback
■
To disconnect iPod or iPhone
■
Navigating the iPod and iPhone menus
1
Press the MENU button to view the menu on iPod or iPhone
unit. Press it again to go back to previous menu.
2
Use the PRESET (
or
) button to select an item on the
menu and then press ENTER button.