XL-E15H_OM_EN.fm
E-12
2009June30
LT (8)
HU (7)
GR (6)
RO (5)
SK (4)
CZ (3)
PL (2)
EN (1)
UA (9)
Listening to the radio
Notes:
z
When radio interference occurs, auto scan tuning may stop
automatically at that point.
z
Auto scan tuning will skip weak signal stations.
z
To stop the auto tuning, press the TUNING/FOLDER
( or ) button again.
To receive FM stereo transmission:
Press the TUNER (BAND) button to select stereo mode and “ST”
indicator will be displayed.
z
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the “ST” indicator. The reception changes to
monaural, and the sound becomes clearer.
You can store 40 FM and AM stations in memory and recall them at
the push of a button (PRESET ( or )).
Note:
The backup function protects the memorised stations for a few hours
should there be a power failure or the AC power lead become
disconnected.
The stations saved in memory can be scanned automatically.
(Preset memory scan).
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER button on the remote control or FUNCTION
button repeatedly on the main unit to select tuner function.
3
Press the TUNING/FOLDER ( or ) button to tune into the
desired station.
Manual tuning:
Press the TUNING/FOLDER ( or ) button as many times as
required to tune in the desired station.
Auto tuning:
When the TUNING/FOLDER ( or ) button is pressed for
more than 0.5 seconds, scanning will start automatically and the
tuner will stop at the first receivable broadcast station.
MICRO COMPONENT SYSTEM
MICRO COMPONENT SYSTEM
XL-E15
XL-E15
PHONES
PHONES
ON/ STAND-BY
ON/ STAND-BY
REMOTE
REMOTE
SENSOR
SENSOR
ON/ STAND-BY
ON/ STAND-BY
FUNCTION
FUNCTION
AUDIO IN
AUDIO IN
PRESET
PRESET
TUNING
TUNING
DISP
DISP
MEMORY /
MEMORY /
TUNER
TUNER
[BAND]
[BAND]
FOLDER
FOLDER
FM stereo mode indicator
Memorising a station
1
Perform steps 1 - 3 in “Tuning” on page 12.
2
Press the MEMORY/DISP button to enter the preset tuning
saving mode.
3
Within 5 seconds, press the PRESET ( or ) button to select
the channel to be preset.
4
Press the MEMORY/DISP button.
In this example, “103.25 MHz” FM station is preset on FM
channel 9.
5
Repeat steps above to add more preset stations.
z
When presetting a new station, the previous preset station
is cleared.
To recall a memorised station
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
To scan the preset stations
1
Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the desired
station is located.
PRESET
PRESET
Summary of Contents for XL-E15H
Page 24: ......
