XL-E15H_OM_EN.fm
E-14
2009June30
LT (8)
HU (7)
GR (6)
RO (5)
SK (4)
CZ (3)
PL (2)
EN (1)
UA (9)
Timer and sleep operation (continued)
The radio, compact disc and audio in mode can all be turned off
automatically.
To confirm the remaining sleep time:
To cancel the sleep operation:
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
Enhancing your system
The connection lead is not included. Purchase a commercially
available lead as shown below.
Note:
To prevent noise interference, place the unit away from the
television.
z
Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and
headphones can cause hearing loss.
z
Before plugging in or unplugging the headphones, reduce the
volume.
z
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
z
Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
Sleep operation
1
Play back the desired sound source.
2
Press the SLEEP button repeatedly to select the time.
(Maximum: 90 minutes - Minimum: 10 minutes)
3
The unit will enter the power stand-by mode automatically after
the preset time has elapsed.
1
Press the SLEEP button once.
z
The remaining sleep time is displayed for about 10 seconds.
z
You can change the remaining sleep time whilst it is
displayed by pressing the SLEEP button (step 2).
1
Press the SLEEP button repeatedly to select “SLEEP 00”.
To use timer and sleep operation together
1
Set the sleep time (see “Sleep Operation”).
2
Whilst the sleep timer is set, set the timer playback (steps 2 -
14, page 13).
Timer playback start time
Sleep operation will
automatically stop
Timer playback setting
Sleep timer setting
End time
Desired time
90 minutes
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio player etc.
to the AUDIO IN socket.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button.
4
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
If volume level is too low, increase the volume of the connected
device.
Headphones
MICRO COMPONENT SYSTEM
MICRO COMPONENT SYSTEM
XL-E15
XL-E15
PHONES
PHONES
ON/ STAND-BY
ON/ STAND-BY
REMOTE
REMOTE
SENSOR
SENSOR
AUDIO IN
AUDIO IN
PRESET
PRESET
PHONES
PHONES
AUDIO IN
AUDIO IN
Portable audio player, etc.
Audio cable
(not supplied)
Summary of Contents for XL-E15H
Page 24: ......
