03/8/20
XL-MP45H(H)E3.fm
E-23
ENGLISH
XL-MP45H
TINSZ0227SJZZ
Advanc
e
d Featu
res
Using the Radio Data System (RDS) (continued)
!
Using the Auto Station Programme Memory
(ASPM)
Whilst in the ASPM operation mode, the tuner will automatically
search for new RDS stations. Up to 40 stations can be stored.
If you have already stored some stations in memory, the number of
new stations you can store will be less.
To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations.
The stations which are already stored in memory will be kept there.
Notes:
"
If the same station is broadcasting on different frequencies, the
strongest frequency will be stored in memory.
"
Any station which has the same frequency as one stored in mem-
ory will not be stored.
"
If 40 stations have already been stored in memory, the scan will
be aborted. If you want to redo the ASPM operation, erase the
preset memory.
"
If no stations have been stored in memory, "END" will appear for
about 4 seconds.
"
If the RDS signals are very weak, station names may not be
stored in memory.
To erase one of the contents of preset memory:
To erase all of the contents of preset memory:
Perform to "To erase entire preset memory" on page 16.
To store a station name again if the wrong name was stored in
memory:
It may be impossible to store station names in memory using the
ASPM function if there is lots of noise or if the signal is too weak. In
this case, perform as follows.
Notes:
"
The same station name can be stored in different channels.
"
In a certain area or during certain time periods, the station names
may temporarily be different.
1
Press the TUNER (BAND) button to select
"FM".
2
Press and hold down the ASPM button for
at least 3 seconds.
1
After "ASPM" has flashed for about 4 seconds, scanning will
start (87.50 - 108.00 MHz).
2
When an RDS station is found, "RDS" will appear first, and
then "MEMORY" and the preset channel number will flash
for 2 seconds. Finally the station will be stored in memory.
3
After scanning, the number of stations stored in memory will
be flash for 4 seconds.
1
Press the PRESET ( or ) button to select the preset channel
number you want to erase.
2
Press the MEMORY button.
3
Within 30 seconds, press the CLEAR button.
1
Press the PRESET ( or ) button to check whether the names
are correct.
2
If you find a wrong name during receiving the station, wait until
the correct name will be displayed. And then press the MEMORY
button.
3
Within 5 seconds, press the MEMORY button whilst the preset
channel number is flashing.
"
The new station name has been stored in memory correctly.
