E-11
ENGLISH
XL-UH3H
B
asic Op
erati
o
n
Setting the clock
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Press the CLOCK/TIMER button. The time display will appear for
about 5 seconds.
Notes:
z
To reset the clock if the power fails or is unplugged, the unit must
be in the STAND-BY mode.
z
"0:00" or time will flash when the AC power supply is restored after
a power failure or unplugging the unit or when reset button is
pressed.
Readjust the clock as follows:
To readjust the clock:
Perform "Setting the clock" from beginning.
PRESET
1
In STAND-BY condition.
2
Press the CLOCK/TIMER button for more than 2 seconds.
3
Within 10 seconds, press the PRESET ( or ) button to
set hour.
4
Press the CLOCK/TIMER button again.
5
Within 10 seconds, press the PRESET ( or ) button to
set minute.
6
Press the CLOCK/TIMER button. The clock is set.
