l
If a connector is disconnected, or a similar problem occurs
during data transfer, the message “I/O DEVICE ERROR”
will appear. Press
to clear the error.
l
After data transfer, the data on the transmitter is unchanged.
Transferring data between
Organizers
Data in the SCHEDULE, ANN, TEL, MEMO and EXPENSE
modes can be transferred. The data is transferred and verified
by mode (all entries in a mode or a directory TEL TEL 2,
TEL 3) or by entry. In addition, data can be backed up.
Transferring data by mode or by entry
During mode transfer, data previously stored in the specified
mode of the receiver is deleted. Proceed with caution.
Note: When mode transfer is carried out in the TEL mode, all
listings in the specified directory will be transferred. (In
this case, the directory file name is transferred at the
same time.)
Select the mode on the transmitter and receiver.
l
Press
(Transmitter)
l
Press (SCHEDULE]. (Receiver)
Press (MENU),
then 2 (“OPTION”), the data transfer
function on the receiver.
Press 2 (“RECEIVE”) to set the unit in the receive mode.
Press
then 2 (“OPTION”), the data transfer
function on the transmitter.
Note:
To transfer a single entry display the desired entry and
press (MENU]
2.
5. Press 1 (“SEND”) to transfer data.
Notes:
If the mode of the transmitter and the mode of the receiver
are not the same, data transfer is not established. The
message “DATA ERROR” is displayed.
When transferring TEL data, directories on the transmitter
and receiver can be different. The contents received by the
receiver will be stored in the open directory. For example, if
TEL 1 is selected on the transmitter and TEL 3 on the
receiver before the data transfer is established, the contents
of TEL 1 will be sent to and stored in TEL 3.
