- 3 -
HOW TO USE TREATMENT TWEEZERS WITH THE FINE FACIAL HAIR REMOVER (CONT.)
HOW TO USE FACE AND BODY PADS WITH THE FINE FACIAL HAIR REMOVER
1. Thoroughly clean treatment area and remove any makeup. The area must be completely
clean, dry and non-greasy. Cut long hairs as short as possible with scissors or a razor before
use.
2. Plug the Treatment Tweezers into the jack on the end of the Fine Facial Hair Remover.
3. Apply conductive gel to the target area and to the tweezer tips.
4. Slide the switch to PROBE mode.
5. Select and hold hair to be treated between tweezer tips. When tweezers are squeezed
together the green conductivity LED light will illuminate and bleep.
6. Gently remove hair in the direction of growth on the upper lip and face, eyebrows or chin
using the tweezers.
Note: If tweezers can’t grip hair to pull out, remove surplus gel from treatment area and tweezers.
This versatile device also removes body hair with the facial and body pads. Consult your manual
for additional instructions and important safety warnings.
1. Thoroughly clean treatment area as before.
2. Insert lead into jack socket at the end of The Fine Facial Hair Remover.
3. Carefully apply the upper lip or rectangular pad to the area so that it adheres to the skin.
4. Place the circular conductivity pad near the upper lip or rectangular pad and push the
white lead clip onto the upper lip or rectangular pad button.
5. Push the green lead cap onto the circular conductivity pad.
6. Slide the button on the Fine Facial Hair Remover from OFF to the FACE PAD or
BODY PAD position.
7. The red power light will illuminate to show power on. The green conductivity light illuminates
to show good conductivity.
8. You’ll hear one beep to start the first stage of 6-minute treatment (or 11-minute treatment for
Body Pad Mode).
Note: FACE PAD MODE: Treatment time - 6 minutes (2.5 minutes on 1 minute rest, 2.5 minutes
on). BODY PAD MODE: Treatment time - 11 minutes (5 minutes on 1 minute rest, 5 minutes on).
5. Put the device on the hair removal area and press the silver activator button. The green LED
light will come on when you’ve made good contact with the conductive gel, and a buzzer will go
off after 20 seconds to notify you that the treatment is finished.
Note: If you do not touch the gel continuously the green conductivity light will go out. Do not
exceed one 20 second treatment per day in one treatment area-2 cm diameter. Maximum of 3
treatments per week in one treatment area.
Note: To avoid shock do not hold the silver activator button down after the green conductivity LED
light illuminates.
HOW TO USE COTTON BUD TO REMOVE HAIR WITH THE FINE
FACIAL HAIR REMOVER (CONT.)
