Flashlight Operation
Slide the Torch switch to ON or OFF to control the dual LED
flashlight.
USING THE ALARM
To Set the Alarm Time
1. Press the “+” or “–” button repeatedly to set the alarm time.
The alarm time will be shown on the screen, along with the
“AL” icon to show that you are changing the alarm time.
2. Holding down either the “+” or “–” button changes the alarm
time at high speed.
To Active the Alarm Function
1. Slide the ALARM switch to the ON position. The icon will
appear. The alarm function is now activated.
2. When the alarm sounds, press the SNOOZE/LIGHT button.
The alarm will be silenced, and the alarm will sound again
at the same time tomorrow.
3. To deactivate the alarm function, slide the ALARM switch
to the OFF position.
To Active the Snooze Function
1. Slide the alarm to “SNOOZE” position, the icon and Zz
will appear on the time display. The snooze function is now
activated.
2. When the alarm sounds, press the SNOOZE / LIGHT
button. The alarm will be silenced and sound again in
approximately 5 minutes.
3. To deactivate the alarm when the Snooze Function is on,
you must slide the ALARM switch to the OFF position.
Lock Function
After you set your time and alarm time, slide the switch to
the KEY LOCK position to protect the time and alarm settings
against any unnecessary changes in transit.
Check Temperature
The temperature is displayed in the Temp field. “Hi” or “Lo” will
be shown if the temperature is out of the measurement range.
Resetting the Unit
In the unlikely event of a malfunction, you may reset the
device to factory settings. Slide open the battery door and
press the RESET button with a pencil or a paper clip.
