- 2 -
STEP 2: PREPARE THE CAMERA.
• Insert a Micro SD card (not included) into the camera. This camera supports Class 4
to Class 6 cards, from 4GB to 32GB capacity.
• Insert the rechargeable battery into the camera.
• Charge the camera by connecting the charging cable and plugging it into a USB port.
• Attach the camera onto the gimbal. Power on the camera. You can press the buttons on
the camera to shoot pictures and videos. Users can also use the transmitter to to control
the camera and play back videos.
STEP 3: ATTACH THE GIMBAL TO THE DRONE.
• Carefully position the gimbal at the bottom
slot with shock resistance equipment slot
and slip it into the bottom of the frame.
• Insert the gimbal signal wire into the
slot on the gimbal.
• Insert the camera image transmission
wire into the left slot.
• Connect the power plug.
STEP 4. CALIBRATE THE GIMBAL.
• Keep the drone on a level surface and do not move it.
• The gimbal will enter calibration mode automatically and finish calibrating in 60 seconds.
STEP 5. INSTALL THE PROPELLERS.
• Take out the four propellers and install
them on the corresponding motor shafts.
• There are 2 types of propellers, “A” and “B.”
Be sure each propeller is on the
correct shaft.
• Lock rotors in place by twisting them
gently in a clockwise direction.
NOTE: These propellers are sharp. Please
wear gloves to perform this step.