STEP 6. INSTALL THE ANTENNA.
• Align the antenna with the Professional
Video Drone.
• Turn clockwise to fasten it.
• Make sure antenna is straight and in
line with the undercarriage.
STEP 7. INSTALL TRANSMITTER BATTERIES.
STEP 8. CALIBRATE THE TRANSMITTER.
• Open the transmitter battery cover
and take out the battery holder.
• Insert 8 AA batteries (not included)
according to the correct polarity
• Insert the plug into the power jack.
Fasten the cover with a screw.
• Push the left joystick to the TOP LEFT and the right joystick to the TOP RIGHT. Hold them
in this position and turn on the transmitter. The LCD screen will show “Calibrate Stick.”
Move the joysticks in a circling motion about three times. Then release and press any
trim button to save stick calibration
.
STEP 9. CALIBRATE THE DRONE COMPASS.
• After the drone powers on, the blue LEDs of the drone will blink in a rotating pattern.
• Put the drone on a level surface and do not move it.
• The transmitter display will show “Check Compass” indicating that the drone is checking
the compass.
• Keep the drone on a level surface and slowly rotate it until the “Check Compass” disappears.
NOTE: Do not calibrate this drone near a strong magnetic field. Do not calibrate this drone while
you are carrying keys, magnets or mobile phones on your person.
STEP 10. PREPARE FOR TAKEOFF!
• Make sure the transmitter and drone have full battery power.
• Make sure the propellers are tight, not damaged and installed correctly.
• Check the gimbal installation.
• Make sure all motors are working before takeoff.
• If you have never flown this model before, please refer Section 9 (Page 23) of your
User’s Guide for basic flight instructions.
Consult the full User’s Guide for information about formatting the memory card, recording video
and other advanced features.
- 3 -
