- 2 -
CHARGING THE DRONE BATTERY
INSERT BATTERIES IN TRANSMITTER
PAIRING THE DRONE WITH THE TRANSMITTER
LIFTOFF AND LANDING
1. Turn power off on the drone
(switch on bottom of aircraft).
2. Open the battery compartment
and carefully remove battery.
3. Disconnect the battery from the
battery cable.
4. Plug the USB charging cable into the battery.
5. Connect the other end of the charging cable to a computer USB port.
6. An LED on the charging cable will off, indicating that the battery is being charged.
7. When the battery is fully charged (about 1.5 hours), the LED will turn on.
8. Disconnect the battery from the charging cable when it is fully charged. Do not overcharge.
1. Open the battery compartment on the transmitter.
2. Insert 4 AAA batteries (included), being careful to
follow the polarity diagrams inside the compartment
(“+” or “-”).
3. Close the compartment.
NOTE: We recommend alkaline
batteries. Always use fresh batteries. For best results, do
not mix old and new batteries.
1. Turn the drone power on.
2. Place the drone on a flat, level surface, with the tail end (green LEDs) pointed toward you.
3. Press the power button on the transmitter. You will hear a beep.
4. Push the throttle level (left stick) to the highest position, then pull it straight down
to the lowest position. You will hear one beep for each throttle movement.
5. When the drone LEDs stop flashing and remain on, you have successfully paired the
drone with the transmitter.
NOTE: It is possible to fly two or more of these drones together,
however they must be paired one at a time.
1. To lift off, press the “START/LANDING” button to start the aircraft. At this time,
the motors of the aircraft will be running slowly. Push the throttle lever upward
to increase power and take off.
