- 3 -
5. Turn on the Compressor On/Off Switch. Monitor the air pressure on the Pressure
Gauge.
DO NOT
run the compressor for more than 30 seconds.
6. When you reach the correct pressure, turn the compressor OFF and disconnect the
power cable from the device.
TIP:
For the protection of your pipes, always start with the MINIMUM recommended air
pressure. If the clog remains, try again with increased air pressure.
7. Hold the Electric Plumber over the drain at a 90° angle. Press firmly to seal the head
against the drain to prevent splashing. If there are two sinks connected, block the
drain of the second sink in order to prevent splashing. For a clogged toilet, attach the
Inflatable Toilet Head. Squeeze the hand pump until the head has a tight seal inside
the toilet. See the illustrated Technique Guide below.
Note:
Press the button on the hand pump to release the air from the Inflatable Toilet
Head.
8. Push the Pressure Release Trigger to deploy a burst of compressed air that will
remove the clog and/or odor.
9. Repeat steps 5-8 if necessary. Do not exceed maximum recommended pressure. To
prevent overheating, do not use this device more than 6 times in a row.
PRESSURE GUIDE
