A552
Rev. F 2/15
10
4. Allow the Stainless Steel Filter and Honeycomb Pre-Filter to
dry completely before inserting them back into the Ionic
Comfort
®
Quadra unit. They can be dried either in the dishwasher
or allowed to air dry. Typically, evaporative air drying can take
12-24 hours, depending on humidity and temperature.
5. Install the Honeycomb Pre-Filter back into the bottom of the
Stainless Steel Filter Assembly. Don’t worry: both ends are the
same, so it can be inserted either way. Never operate the
unit without the Honeycomb Pre-Filter.
6. Insert the cleaned and dried Stainless-Steel Filter Assembly
back into your Sharper Image
®
Ionic Comfort Quadra unit.
If you have reinstalled the Stainless Steel Filter Assembly after
cleaning and drying, and hear “crackling” after turning it on,
your filter is still wet. Turn the unit off, remove the Filter
Assembly and allow it to dry longer.
Note:
Do not allow the dishwasher rack to bend the Stainless Steel
Filter Plates or break the Ionizer Wire. Care must be taken
when positioning in the dishwasher. Your air purifier will not
function properly if the Stainless Steel Plates touch each other
or the Ionizer Wire breaks.
CAUTION
Sink Cleaning
Remove the Honeycomb Pre-Filter from the Stainless
Steel Filter Assembly and place both components in your
sink. Rinse to remove large debris. Submerge both filters
in warm water that contains standard dish washing soap.
Allow the filters to soak for at least 15 minutes, drain the
sink and rinse the filters with cold water.
Note:
You may use a small-headed scrub brush to clean
stubborn residue between the Stainless Steel Plates or
Honeycomb Pre-Filter. However, take care not to bend the
Stainless Steel Plates or apply pressure to the Ionizer Wire.
A552
Rev. F 2/15
10
4. Allow the Stainless Steel Filter and Honeycomb Pre-Filter to
dry completely before inserting them back into the Ionic
Comfort
®
Quadra unit. They can be dried either in the dishwasher
or allowed to air dry. Typically, evaporative air drying can take
12-24 hours, depending on humidity and temperature.
5. Install the Honeycomb Pre-Filter back into the bottom of the
Stainless Steel Filter Assembly. Don’t worry: both ends are the
same, so it can be inserted either way. Never operate the
unit without the Honeycomb Pre-Filter.
6. Insert the cleaned and dried Stainless-Steel Filter Assembly
back into your Sharper Image
®
Ionic Comfort Quadra unit.
If you have reinstalled the Stainless Steel Filter Assembly after
cleaning and drying, and hear “crackling” after turning it on,
your filter is still wet. Turn the unit off, remove the Filter
Assembly and allow it to dry longer.
Note:
Do not allow the dishwasher rack to bend the Stainless Steel
Filter Plates or break the Ionizer Wire. Care must be taken
when positioning in the dishwasher. Your air purifier will not
function properly if the Stainless Steel Plates touch each other
or the Ionizer Wire breaks.
CAUTION
Sink Cleaning
Remove the Honeycomb Pre-Filter from the Stainless
Steel Filter Assembly and place both components in your
sink. Rinse to remove large debris. Submerge both filters
in warm water that contains standard dish washing soap.
Allow the filters to soak for at least 15 minutes, drain the
sink and rinse the filters with cold water.
Note:
You may use a small-headed scrub brush to clean
stubborn residue between the Stainless Steel Plates or
Honeycomb Pre-Filter. However, take care not to bend the
Stainless Steel Plates or apply pressure to the Ionizer Wire.
Rev. G 5/15
