WEEKLY CLEANING CPAP WITH
NON-REMOVABLE WATER RESERVOIR
Note:
If your water reservoir is removable, follow instructions above for daily cleaning.
Step 1.
Disconnect Mask from CPAP hose
Step 2.
Connect CPAP hose to the CPAP Cleanerʼs Hose Port (Figure 13). If hose end does not fit snuggly, attach hose
to one of the 2 Universal Fit Adapters and attach adapter end into the CPAP Cleanerʼs Hose Port (Figure 13).
Step 3.
Place CPAP machine with non-removable water reservoir into large cleaning zip bag with connected hose
and the CPAP Cleaner (Figure 14) then zip cleaning bag closed completely so there are no leaks
(Figures 15-16).
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
Step 4.
Turn on the CPAP Cleaner by pressing down on On/Off Button for 3 seconds. This will start 30-minute cleaning
cycle and clean the hose and Water Reservoir. The CPAP Cleaner will turn off automatically and beep at the
end of the cleaning cycle (Figure 17).
Step 5. Leave CPAP machine, hose and the CPAP Cleaner in sealed Zip bag for 1 hour after cleaning
cycle to allow residual activate oxygen (ozone) to revert to ordinary oxygen.
PAGE 2
Figure 10
Figure 9
Figure 12
Figure 11
Closed
Step 2.
Remove and empty water reservoir from CPAP machine (Figure 8).
Step 3.
Place empty water reservoir, and mask with hose attached to the CPAP Cleaner into large
Cleaning Zip Bag (Figure 9).
Step 4.
Zip Cleaning Zip Bag completely closed so there are no leaks (Figures 10-11)
Step 5.
Turn on the CPAP Cleaner by pressing down on On/Off Button for 3 seconds (Figure 12). Blue light indicates
start of 30-minute cleaning cycle to clean hose, mask and water reservoir. The CPAP Cleaner will turn off
automatically and beep at the end of the cleaning cycle.
Step 6. Leave water reservoir, mask and hose in sealed Cleaning Zip Bag for 1 hour after cleaning
cycle to allow residual activated oxygen (ozone) to revert to ordinary oxygen.
Figure 8
