8
9
Listening to Other Portable Audio Devices:
If you have an iPod
without
a docking port or a different MP3 player, including
other portable audio devices you may play them through the dock for iPod
iBeam
®
Sound System through the built-in AUX-IN jack, located behind the
main unit.
1. Ensure the speaker dock is OFF.
2. Plug your audio device into
AUX IN
socket (located behind the main unit).
3. Press the
power
button
/
to turn the speaker dock ON.
NOTE:
You may need to turn your external audio device ON as well.
4. Press the
skip
buttons
OR
to rewind or fast-forward to the next song.
5. Press and hold the
power
button
/ more than 3 seconds to turn the unit
OFF.
NOTE:
You may need to turn your external audio device OFF as well.
Using Headphones (not included):
If you would like to listen to your music privately through the use of headphones,
you may do so in one step. Simply plug your headphones into the
phones
socket, located behind the unit. Compatible headphones have a 3.5mm diameter
stereo plug and an impedance of 8-32 Ohms. When your headphones are
connected, the stereo speakers are automatically disconnected.
QUICK REFERENCE TROUBLESHOOTING
If an issue arises, please refer to the points listed below. If you are unable to remedy
a problem by following the table, please consult the SI Products Service Center. The
contact information is listed under the ONE YEAR LIMITED WARRANTY.
WARNING:
Other than basic troubleshooting, under no circumstances should you
try to repair the unit yourself, as this would invalidate the warranty. NEVER operate
this appliance if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water.
PROBLEM
POSSIBLE REASON(S)
SOLUTION
There is no sound coming
from speakers.
• Volume not adjusted.
• Headphones are connected.
• Adaptor is not correctly
connected to power supply.
• Adjust the volume.
• Disconnect the headphones.
• Connect the adaptor properly.
The main unit does not
react to any button being
pressed.
Electrostatic discharge
Turn off the unit, disconnect the adaptor
plug from outlet and then reconnect after
a few seconds.
The iPod does not respond
to the unit or the iPod did
not charge up.
The iPod is not installed properly
in the docking connector base.
Remove your iPod from the dock and
check for obstruction on the connectors
in the dock and on the iPod. Then insert it
back into the docking connector base.