- 3 -
OPERATING INSTRUCTIONS (CONT.)
CARE AND MAINTENANCE
• Wipe the inside and allow to air dry thoroughly after every use.
• Do not allow water to stagnate inside the device.
• Clean the interior with a diluted solution of water and vinegar.
• Do not immerse in water.
• Do not spray ice maker with chemicals.
• Rinse thoroughly before starting. Remove the rubber stopper and allow excess water to drain
out the bottom.
(NOTE: If the compressor stops for any reason such as water shortage, too much ice, power failure,
etc. do not start the system right away. Wait 3 minutes, and then re-start the ice maker.)
CAUTION: It is normal for the compressor and condenser surface to become warm or hot. Please
exercise caution, and make sure there is proper ventilation (at least 6” around the top, back and
sides).
CAUTION: This device is not a toy. Keep out of reach of children at all times.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SUGGESTED SOLUTIONS
“ADD WATER” light is on.
1. Water level too low.
2. There is air in the line.
1. Press the ON/OFF button, fill reservoir
with water. Wait 3 minutes and press
the ON/OFF button to restart. When the
water has reached the fill line, the ice
maker will restart automatically.
2. Remove the rubber stopper and let
several drops water runs out.
The ice cubes are too large / ice cubes
are sticking together.
Ice from previous cycles is left in the
water tray.
Turn the unit OFF and allow ice in the
system to melt.
The “ICE FULL” and “ADD WATER” lights
are on simultaneously.
Water tray is blocked by an ice cube. Clear the ice cube from under the ice
shovel.
Remove the plug from the AC outlet and
plug it back in.
Press the “ON/OFF” button. The ma-
chine will restart within two minutes.
