12 | ENGLISH
PROPER STORAGE
Preparing your 2-in-1 Steam Iron and Fabric Steamer for storage is
quick and simple. When you have finished your steaming tasks, follow
the steps listed below.
1.
Set unit on the Resting Plate.
2.
Turn unit OFF and unplug from power source.
3.
Allow unit to cool at least 30 minutes.
4.
Drain any remaining water into a sink or tub to minimize potential
build-up.
5.
Press Rotary Button to rotate handle to resting position.
6.
Wrap cord with supplied "hook and loop" fastener when storing.
7.
Store unit in cool, dry place.
MINERAL BUILD-UP
A common maintenance need for steam appliances is the removal
of build-up caused by high mineral content in many municipal water
supplies. This mineral build-up may cause the unit to spew water, limit
the effectiveness and reduce the life of your 2-in-1 Steam Iron and
Fabric Steamer.
The best way to minimize mineral build-up is to use distilled or de-
mineralized water when using your 2-in-1 Steam Iron and Fabric Steamer
.
TO REMOVE MINERAL BUILD-UP
1.
Follow Steps 1-4 under Proper Storage section.
2.
Fill measuring cup with 1.0oz (29.6mL) of distilled water and 1.0oz
(29.6mL) of vinegar.
3.
Slowly pour water-vinegar solution into Water Tank, then replace
Water Tank Cover.
4.
Plug in power cord and turn unit ON. Unit will immediately begin to
heat.
5.
Point Ironing Plate into a sink or tub and press the Steam Button to
allow unit to produce steam for 1 minute. Then, turn unit off and
STORAGE & CARE