18
PROGRAMMING ID LOCK
TheAtlas PVR Universal Remote Control is locked at the
factory to operate a Motorola Digital Cable Terminal
(DCT). However, if you have another brand or model of
cable converter or satellite service that you would like to
control, then you’ll need to perform the following steps
to unlock the ID Lock, enter a new manufacturer’s code,
and lock the ID Lock again.
1.
Turn on the cable converter.
4.
Perform the instructions under
“Programming Device Control” on page 8 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
USING THE MASTER POWER KEY
The Atlas PVR Universal Remote Control has a unique
feature that allows you to sequentially turn up to five of
your home entertainment devices on or off with a single
key press.
NOTE:
MASTER POWER (PWR)
only works in the
CBL
mode. If it is not programmed, only the cable
converter will turn on or off. In any other
mode, pressing
MASTER POWER (PWR)
once
will turn the selected device on or off.
2.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice.
3.
Enter
9 8 2
. The
CBL
key will blink four
times, indicating ID Lock is unlocked.
5.
On the remote control, press
CBL
once; it will
blink once. Then press and hold
SETUP
until
the
CBL
key blinks twice.
6.
Enter
9 8 2
. The
CBL
key will blink twice,
indicating ID Lock is again locked.
Atlas Shaw M1055FR Rev 1 Eng only.fm Page 18 Wednesday, October 5, 2005 5:28 PM
Summary of Contents for ATLAS PVR
Page 1: ...ATLAS PVR Universal Remote Control Users Guide ...
Page 44: ...44 M11055 FS ...
