Before Each Use
Inspect the electrical cord for damage.
Inspect pump tube.
Make sure the pump tube is completely unwrapped
and not kinked. Failure to do so can cause water to back up in the pump
and leak out. The control panel may signal this problem by displaying
“ER01
Touch Pad Keys (Cont.):
PURGE.
Press the PURGE key to empty water from the pump reservoir.
During the normal operation, the pump purges automatically whenever
the reservoir is full. The display will read PURGE ON icon.
TO PURGE THE PUMP MANUALLY BEFORE TRANSPORTATION:
Stop the dehumidification using the START/STOP key, and let the
unit sit for about 10mins. This allows water to drip from the coils.
Press PURGE to remove residual water.
DISPLAY.
Press the DISPLAY key to display “TIMER” CLOCK,
“TOTAL” CLOCK and “JOB” CLOCK while the machine has been turned
on. Press the DISPLAY key once can only display ONE kind of clock
time.
In STANDBY MODE, the default display is “TIMER” CLOCK time.
By press the DISPLAY key once to display the
“TOTAL” CLOCK
time. Press it again to display
“JOB” CLOCK time, which shows the
LAST JOB run time.
While the dehumidification stops as the
“TIMER” set, the default
CLOCK
display is “TIMER” CLOCK time, which shows remaining
running time of the CURRENT JOB. Press the DISPLAY key once
to display the
“TOTAL” CLOCK time. Press it again to display “JOB”
CLOCK time, which counts the CURRENT JOB run time.
While the dehumidification runs continuously without
“TIMER”
setting, the default CLOCK display is
“JOB” CLOCK, which shows
the CURRENT JOB running time. Press the DISPLAY key once to
disp
lay “TIMER” CLOCK time, which reads “00:00”. Press it again
to display the
“TOTAL” CLOCK time.
If the DISPLAY key has not been pressed within 15 seconds, the
CLOCK time will back to its default display.
When error messages are on,
“TIMER”, “TOTAL” and “JOB”
CLOCK displays disappear. Press DISPLAY key once to get the
clock displays back.
Operating Your Dehumidifier
Place the dehumidifiers in upright position
If the dehumidifier has been laid down in a horizontal position for any time over
a few minutes, you must set it upright (vertical) for 30 minutes before starting.
Connect the drainage system
You can find the hose wrapped around the back of the machine. Unwrap the
entire hose and run it into a sink, toilet, drain, or bucket. Remove any kinks in
the hose. Use bleach in the condensate pump once a year to keep clean.
Plug in the electrical cord
Locate the electrical cord and unwrap around the air outlet located on the back
of the unit. Plug it into a standard outlet with the correct voltage and amperage
for the unit. If you use the optional 230v to 115 volt converters that allow you
to plug in multiple units at the same time into your customers electric clothes
dryer, stove or oven, always check the voltage with our optional volt meters.
Before Transporting Your Dehumidifier
Before moving the unit, make sure the pump is empty of water. To do this, let
the unit stop dehumidification for 10mins. Push PURGE key to clear waters.
