Make sure the switch on the side of the clipper is in the "OFF"
position. Then insert the plug into an electrical outlet. Slide the
switch to the "ON" position and begin clipping.
OILING AND CLEANING THE BLADES:
Keep the clipper blades oiled and clean well while clipping.
When clipping is completed, remove the blades and wash them
in Blade Wash. Wipe the blades and the other parts and secure
cord and place in original carton with clipping head to prevent oil
from seeping down the armature shaft into the motor.
CLEANING THE AIR FILTER:
Ensure that the air filter is free of hair and dirt.
The hair and dirt that collect on the filter screen must be
frequently removed so that air can freely pass through the screen
to cool the motor.
RESHARPENING:
Sharp blades, combs and cutters are essential for good clipping
and shearing. Dull blades must be sharpened with special
grinding discs. These discs and custom sharpening facilities are
available through:
WE RECOMMEND:
Botany Bay Imports Exports Pty Ltd
PO Box 260 Botany NSW 1455
Phone: 02 9700 0800 Fax: 02 9700 1171
Email: info@botanybayimports.com.au
www.botanybayimports.com.au
5
BEFORE BEGINNING TO CLIP
MAINTENANCE
IMPORTANT
Do not remove the head from motor housing.
Contact an authorised service centre for service
Summary of Contents for STALLION 300
Page 2: ...2 COMPONENT NAMES...
