AFTER SALES SUPPORT
PROLINK ASIA LTD
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm
Page 8
Using the Defrost Button
To toast frozen bread, do not adjust the browning control, place the bread
normally in the bread slot, depress the bread carriage lever and press the frozen
bread button
The light next to the button will illuminate and the toaster will automatically toast
for an extended period.
Using the Re-heat Button
If your toast has popped up and gone cold, the toaster offers a re-heat facility. To use,
depress the bread carriage lever and press the re-heat button immediately. The light
next to the button will illuminate and the toaster will operate for a short period re-
heating the bread.
Crumb Tray
Crumbs will accumulate in the crumb tray and could catch fire if not emptied
periodically. When the toaster has cooled down completely, tap the sides of the case
lightly to dislodge any crumbs lodged in the toasting chamber and pull out the crumb
tray .Empty the tray and replace it.
NOTE:
Never operate the toaster without the crumb tray fitted.
Additional Points
In order to achieve uniform browning, we recommend you wait a minimum of 30
seconds between each toasting, so that the control can automatically be reset.
If toasting one slice only, you may need to adjust the browning control to a
slightly lower setting.
Note
you will also notice a slight variation in toast colour on
one side of a single slice.
Stale bread toasts more rapidly than fresh bread. The browning control should be
set at a lower setting than usual.
All sorts of bread can be used as well as muffins, crumpets etc. Slices should not
however be so thick as to cause burning or jamming within the bread slot.
When toasting 2 slices it is recommended they are of equal size and freshness.
Allow the toaster to cool fully before putting away.
