background image

 

If the bread in your toaster becomes jammed disconnect your toaster at the socket, 

allow it to cool, and then remove the bread. 
 

When not in use, switch your toaster off at the mains and remove the plug from the socket.  

DO NOT WRAP THE CABLE AROUND THE MAIN BODY OF THE APPLIANCE DURING 
OR AFTER USE. 

 

Using the cancel setting 

If you wish to interrupt the toasting process, press the cancel button. 
 

Using the re-heat button 

If your toast has popped up and gone cold, the toaster offers a re-heat facility. To use, depress 
the bread carriage lever and press the re-heat button immediately. The light next to the button 
will illuminate and the toaster will operate for a short period re-heating the bread. 

 

Using the Frozen button 

 

To toast frozen bread, do not adjust the browning control, place the bread normally in the 

bread slot, depress the bread carriage lever and press the defrost bread button 

 

The light next to the button will illuminate and the toaster will automatically toast for an 

extended period. 

 

Crumb tray 

Crumbs will accumulate in the crumb tray and could catch fire if not emptied periodically. When 
the toaster has cooled down completely, tap the sides of the case lightly to dislodge any crumbs 

lodged in the toasting chamber and pull out the crumb tray .Empty the tray and replace it. 

NOTE:

 Never operate the toaster without the crumb tray fitted. 

 

Additional points 

 

In order to achieve uniform browning, we recommend you wait a minimum of 30 seconds 

between each toasting, so that the control can automatically be reset. 

 

If toasting one slice only, you may need to adjust the browning control to a slightly lower 

setting. 

 

Note you will also notice a slight variation in toast colour on one side of a single slice. 

 

Stale bread toasts more rapidly than fresh bread. The browning control should be set at a 

lower setting than usual. 

 

All sorts of bread can be used as well as teacakes, small rolls etc. Slices should not however 

be so thick as to cause burning or jamming within the bread slot. 

 

When toasting 2 slices it is recommended they are of equal size and freshness. 

 

Allow the toaster to cool fully before putting away. 

 

 

Summary of Contents for PLA0405







Reviews: