Maintenance and care
Annually or more often, the unit should be completely inspected internally and externally to make
certain the unit remains properly installed and secured .Particular attention should be paid to:
Hardware-check all carriage bolts and hardware connectors to be certain they are in place and
tightened.
Weather trends, the unit will strain against the base plate flange under windy conditions, pegs
hardware, connection to frame members should be maintained tight and depth of pegs should be
checked to be certain they remain deeply and firmly set.
Snow Accumulation -All snow accumulation on the main cover should be removed as soon as
possible. Tap the main cover from the inside with a broom or soft brush to clear cover.
Main Cover Lacing-the poly rope that secures the main cover to the bottom rail of the frame
assembly should be checked, and adjusted as needed. The tension on the main cover should be
uniform from end and side to side. Rope ends must be tied off onto the frame members at the ends
on each side.
Cleaning -cover and doors can be cleaned with a mixture of light detergent and water. A soft bristle
brush with the mixture can be used to loosen any hard dirt, mold, or buildup on the cover. After
cleansing, the cover should be rinsed thoroughly to avoid any chemical reaction from residual
detergent. Allowing dirt and debris to sit on cover over an extended time will damage cover
irreparably.
Severe Weather-in preparation for inclement weather, completely secure the door of your buildings
portable building. Allowing wind to enter end lifts the
Thanks again for choosing this quality product. The following is the
detailed assembly instructions for you starting the assembly.
