ShelterLogic 10' x 8' x 8' Peak Style Shelter, Assembly Instructions Manual

05-10ET13-0B

Page 9

10110

COVER RAILS

CORRECT

FRonT

ReAR

8. InSTAllInG coVeR And coVeR RAIlS

A. 

Lay the cover on the ground next to the frame with inside of the cover (the side with the pipe pockets) facing  

     down and the webbing on the front and rear of the corner of the building.

B. 

Pull cover over the frame, making sure to center cover on frame. There should be an equal amount of over-   

     hang at all four corners.

C. 

Insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet    

     and pull tight. Wind the ratchet so that the webbing overlaps itself. 

D. 

Disassemble cover rails and slide through fabric pockets at each leg and reattach with clamps to each leg.       

     Repeat this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.

E. 

Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.

NOTE:

 The 

ShelterLogic

®

 logo should

 be oriented as shown below.

Webbing and Ratchets Securing Cover

End Rib Cross Rail Clamps

10115

10112

01010

Middle Rib Cross Rail Clamps

10115

10111

01010