4
tilt within a large degree for your convenience. Install the camera mounts via using the already
placed adhesive, or using screws or zip ties to install these mounts.
❸
Hidden the camera cable safely in the motorcycle and route it back to the main device
location. Ensure the cables are not subjected to a pinch point or in an area that will expose
it to high temperature from the engine.
3. Install GPS Module and remote control
Locate a position to install GPS module that can expose it to the sky. Use the attached
strap to fix the remote control to the handle of the motorcycle, which is convenient for you
to manually operate to capture, lock files, and record voice. Finally hide the excess cables
inside the motorcycle.
4. Install power cord
There is two types to install the supply power:
❶
Using 5 volt, 2A or above output USB port to connect with the host via USB cable.
❷
Connect the host via using the supplied 12 volt to 5 volt converter power cord, and perform
the power connection according to the following steps:
•
Connect the red wire to ignition, accessory port, fuse box or other regulated power.
•
Connect the yellow wire to positive of motorcycle's battery.
•
Connect the black wire to negative of motorcycle's battery.
The installation diagram is shown in the figure below:
5.
Overall installation diagram
Summary of Contents for MD30
Page 1: ...1 ...
