Precautions
1. Find an outdoor open space, horizontally place the aircraft more than 3 m from you,
especially the children to avoid accidental injury.
2. Starting sequence:
(1) Check and make sure the two button switches on remote controllers in the topmost
shift, the left rocker accelerator in the lowest position and the right rocker in the middle
position.
(2) Check whether the remote signal quality on the screen is normal.
(3) Check whether the GPS searching stars are more than 6 and after positioning, the status
indicator light is constant blue.
(4) Pull the accelerator rocker to
↘
the lower right direction and hold it, waiting for
unlocking. (after unlocking the status indicator is constant red and DISARMED
disappears from the screen)
(5) Slowly push the rocker, and when the accelerator is about 20% the motor begins to
rotate and pull the rocker back to 0% to stop the motor, ensuring the accelerator working
normally.
(6) When the accelerator exceeds the middle position, the aircraft can fly and rapidly push
the accelerator to about 65% to make it fly above the ground.
(7) Pay attention to the status of the aircraft and when it flies to the appropriate height, it
can be switched to fixed-height mode (the screen shows ALTH), and under fixed-height
mode, the aircraft can be sensitively operated and controlled to fly around; at this time the
accelerator controls the flying height and try to keep it in the middle position in order to
maintain the flying height.
(8) When the flying height is stable, it can be switched into hovering mode (screen shows
LOIT), and the aircraft has a high wind resistant performance, but the flying control is not
as sensitive as that under fixed-height mode.
3. Under fixed-height or hovering mode, lower the accelerator will slowly descend the aircraft
and after pulling the accelerator to the lowest position, the mode will be switched to STAB
and the motor stops.
4. Pull the accelerator rocker to
↙
the lower left and hold it, and the aircraft will be locked
(screen shows DISARMED)
5. Disconnect the power of the aircraft at first and close the remote control to complete the test
flight.
文件使用
"pdfFactory Pro"
试用版本创建
