www.enc.net.cn/en
Tel/Fax:86-755-26984485/26985120
3 Function parameter schedule graph
9
3 Function parameter schedule graph
3.1 Symbol description
×
---- parameter can’t be changed in process of running
○
---- parameter can be changed in process of running
* ---- read-only parameter, unmodifiable
3.2 Function parameter schedule graph
F0 –basic run function parameter group
function
code
name
Set range
unit
Factory
default
Modificat-
ion
F0.00 Frequency
input
channel selection
0: keypad analog potentiometer setting
1: keypad digital setting
2: terminal UP/DOWN adjust setting (stored after
power off)
3: serial port setting
4: VCI analog setting (VCI-GND)
6: reserved
7: reserved
8: combination setting
9: terminal UP/DOWN adjust setting
(not stored after power off)
10:provision serial port (stored after power off)
1 1
○
F0.01 Freq. digit setting Lower limit Freq.
～
upper limit Freq.
0.01Hz 50.00Hz
○
F0.02 Run
command
channel selection
0: keypad run control
1: terminal run command control
(keypad stop command ineffective)
2: terminal run command control
(keypad stop command effective)
3: serial port run command control
(keypad stop command ineffective)
4: serial port run command control
(keypad stop command effective)
1 0
○
F0.03 Run direction
setting
1
st
bit: 0, forward run; 1, reserved
2
nd
bit: 0, forward run allowed
1, reverse run banned
3
rd
bit: REV/JOG key selection
0: as reverse run key
1: as jog key
1 100
○
F0.04 Acce/Dece mode
selection
0: linear accelerating decelerating mode
1: S curve accelerating decelerating mode
1 0
×
F0.05 S curve start
section time
10.0
（％）－
50.0
（％）
（
Acce/Dece time
）
F0.05+F0.06
≤
90
（％）
0.1(
％
) 20.0(%)
○
Summary of Contents for EDS780 Series
Page 3: ......
