Shenzhen Sailwider Electronics Co., Ltd.
Page 3 of 15
•
Serial
This indicator flashes when there is data flow in the serial port (reserved).
Interface and Buttons descriptions:
•
DC 5V
The DC Jack for power supply.
•
USB
The USB port for power supply (Also reserved for serial devices).
•
LAN
The Ethernet network interface. 10/100 Base-T RJ45 interface to connect with network router.
•
Reset
Press this button to recover the factory default setting. To reset or to clear all paring, history data and web
server setting, press the Reset Button and hold it here for 5 seconds until the right 3 LED indicators all light
up, then release the Reset Button, after 2 seconds, the right 3 LED indicators all light off and all information
has been cleared.
Be cautious to use this button since all data will be lost.
•
RF Link
This button is used to pair the sensor terminals with the gateway.
2. Installation and Operation of the wireless energy Ethernet gateway.
2.1 Installation Preparation
Power Supply: 100-240VAC, 50/60 Hz
Working Temperature: -10-50
℃
Working Humidity: 10-90%, with no
condensation.
2.2 Installation and Pairing
2.2.1 Power on the gateway and connect it with home Ethernet network.
1)
Use the power adapter to connect the gateway’s DC jack with the main power supply until the
power indicator lights up. Or use a USB power adapter to provide power via the gateway’s USB
interface until the Power LED indicator lights up.
2)
Plug Ethernet network cable into the LAN interface of the gateway and connect it with a local
working router or home wall network socket, wait until the Link LED indicator lights up, which means
the Ethernet network link has been established.
3)
The sensor terminals that can be paired with the gateway include the 1-way power transmitter with
sensor clamp (or LED sensor), temperature transmitter, 2-way sensor socket & 2-way RF switch.
2.2.2 To pair a 1-way power transmitter with the gateway:
1)
Keep the power transmitter as close to the gateway as possible. Pull out the clear plastic tab
(marked with “REMOVE BEFORE USING”) from the back of the transmitter. The tab is an insulation
sheet, once it is pulled out, the built-in batteries will make the transmitter start to work immediately.
2)
Press the RF link button of the gateway and hold it there for about 5 seconds until the RF indicator
lights up, then the gateway enters the pairing mode and begins to search for pairing signal.