4
DFU
Use to update firmware
Signal
Flash one time when receive on Tag
Power supply
the power light, bright when having power supply
RF
RF antenna
4 Data Protocol
4.1 Contains the TZ-RD01 ID data format
Begin character (7F) + Data length (1byte) + Tag ID (4byres) + Tag state (1byte)
+ battery voltage (1byte) + temperature (2byte) + check code + end code (03)
Begin character: 0x7F
Data length: 1byte , After the data length and before the checksum;
TZ-RD01 ID: TZ-RD01 ID depends on the command NO.04
TAG ID: received tag06 ID
TAG status
：
1 byte
bit7: Battery voltage status, 1-low Voltage, 0- Voltage normal
；
bit6: Temperature status,1- Temperature more than set high and low
temperature threshold, 0- Temperature normal.
bit5-bit0: reserved;
Battery voltage: 2 byte, Unit: 1mv, 0C 50 means voltage is 3.152V
；
The first bit of temperature means normal/abnormal : 0-normal,1-abnormal
；
The second bit of temperature means po)/negative(-) :
0-positive,1-negative;
After the third bit of temperature means real temperature, unit 0.1
℃
;
For example: 01 64 means +35.6
℃
, 41 64 means -35.6
℃
, 80 00 means
abnormal;
check code: 1 byte, and the accumulation of all the data before;
end code: 0x03.
4.2 Doesn’t Contains the TZ-RD01 ID data format
Begin character (7F) + Data length (1byte) + Tag state (1byte) + battery voltage
(1byte) + temperature (2byte) + check code + end code (03)
The data shows that same as above;
5 Prepare for configuration
5.1 Install PL2303 windows driver
Summary of Contents for TZ-RD01
