10
/
10
3
、
The FCC, the federal communications commission interference statements.
This equipment already through the class B digital equipment testing
The FCC regulations in accordance with article 15 for the regulations set is to give the installation
process may cause harm on the environment to provide the necessary protection. This equipment
in use process will produce radio radiation. If do not follow the instructions for installation and use
may affect the radio and TV receiving signal, can pass open and close this equipment to test.
Users can try to use the following measures to avoid such interference:
1
、
Change the direction of receiving antenna or is rearrange the antenna position.
2
、
The admiral equipment in circuit with the antenna connection distinguishes the connection.
3
、
To distributor or experienced people for help.
This equipment meets FCC article 15 in the following two rules, please use the product:
the premise of
1
、
This device is not cause adverse interference.
2
、
The equipment can overcome the possible existence of interference, including the interference
of the incorrect operation brings.
The FCC, the federal communications commission interference statements:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
