5
3. The device is equipped with a power cord and a plug. Before connecting, make sure the power switch (3) is in the OFF position (off).
Fig. 1. Scheme of connecting devices
7. FUNCTIONAL DESCRIPTION switches and DIAL
Ready for operation, the device attached to the connector (3). The inclusion of devices is confirmed by lighting of the LED (2).
Ready for operation, the device attached to the connector (3). The inclusion of devices is confirmed by lighting of the LED (2).
For storage or transport devices in freezing temperatures before the start of work to bring the device to an appropriate temperature
!!!
Setting the welding current is made knob (4). Recommended values of the welding current depending on the diameter of the electrode for the example
the most commonly used electrodes in the table below. The switch (8) allows you to enable / disable function VRD. Enabling this feature will be
confirmed by lighting of the LED (9). VRD function reduces the rated voltage of no-load condition of 70V to 20V for reasons of safety, however, hinders
the starting performance. Selecting the operating mode to the user. Attention! For safety reasons, it is recommended to use the device enabled VRD.
OVERHEAT
AND
POWER
thirty
200
60
90
120
150
180
2
3
5
6
7
VRD
8
4
1
9
1. Signaling device overheating
2. The LED power
3. The main switch
4. The current control knob
5. Nest "-"
6. Slot "+"
7. Display
8. Switch VRD / standard
9. LED function VRD
Fig. 2. View of the front panel
