OVERHEAT AND ENGINE OIL
PRESSURE ALARM BUZZER
The coolant temperature fluctuates depending
on ambient temperatures and working loads. If
the needle at the“H”end indicates during
operation, the overheat alarm buzzer sounds.
This time take the following steps.
1. Set the PTO of the mower to the OFF-
position.
2. Wipe the air intake panel of chaff and dirt by
hand.
3. Run the engine idle until the meter needle
comes back to the middle area.
4. Stop the engine and check the coolant level
in the reservoir tank.
(1) If the coolant level is lower than LOW
mark, add clean water or antifreeze
solution as necessary.
(2) If there is no coolant left in the reservoir
tank, remove the radiator cap and visually
check the level of the coolant. If the
coolant level is just below the bottom of
the filler neck, add clean water or
antifreeze solution as necessary.
WARNING: THE COOLING SYSTEM OPE-
RATES UNDER PRESSURE WHICH IS
CONTROLLED BY THE RADIATOR CAP. IT IS
DANGEROUS TO REMOVE THE CAP WHILE
THE SYSTEM IS HOT. ALWAYS COVER THE
CAP WITH A THICK CLOTH AND TURN THE
CAP SLOWLY COUNTERCLOCKWISE TO
THE FIRST STOP. ALLOW ALL PRESSURE
TO ESCAPE BEFORE REMOVING THE CAP
COMPLETELY.
ENGINE OIL PRESSURE
When oil pressure falls below 29.4 kPa, the
alarm buzzer will sound same as overheat
situation above 110°C degrees.
NOTE: The alarm buzzer will sound when
engine stops with key left inserted at“ON”
position. In order to stop the alarm buzzer,
return the key to“STOP”position.
SEAT BELT ANCHOR
Check if there is any looseness or damage in
the seat belt anchors located on both right and
left sides.
CELLULAR PHONE SOCKET
•
When you need power, for example, for
using the cellular phone for a long time, the
power can be taken from this socket.
•
A current up to 12V and 20A can be taken
for other power requirements from the
cellular phone outlet.
The plug and cord are provided as standard
accessories and housed in the rear seat pocket.
2-21
OPERATION
Summary of Contents for CM314
Page 1: ...TRACTOR OPERATOR S MANUAL MODEL CM314 CM374 I H I GROUP IHI Shibaura Machinery Corporation...
Page 68: ...4 6 Wiring Diagram...
Page 73: ...4 13...
Page 74: ...4 14...
