3-3
LUBRICATION AND MAINTENANCE
LUBRICATION
Adequate lubrication and maintenance on a
regular schedule is vital to maintaining your CM
mower. To ensure long service and efficient
operation, follow the lubrication and mainte-
nance schedules outlined in this section. The
use of proper fuels, oils, and filters, as well as
keeping the systems clean, will also extend
machine and component life.
ATTENTION: Always use genuine SHIBAURA
replacement filters to ensure proper filtration of
engine and hydraulic systems.
RECOMMENDED LUBRICANTS
Engine Oil................... Service Grade CD
Transmission Oil..........ISO VG 46
Grease.........................High Viscosity Lithium
Base-NLG 1 # 2
LUBRICATION FITTINGS
NOTE: After every 50 hours of normal
operation, apply a good quality grease to the
lubrication points listed below (refer to the
Recommended Lubricants chart). When
operating under extremely dirty conditions,
lubricate more frequently than every 50
hours.
•
Lift cylinder
•
Front Lift arm
•
Power Steering Cylinder
•
Brake pedal shaft
•
Dif. Lock pedal shaft
To lubricate these points:
1. Wipe away all old grease and dirt from the
lubrication fittings to prevent dirt or foreign
material from entering as new grease is
applied.
2. Use a high pressure grease gun to force in
the new grease. Apply pressure until clean
grease oozes from each lubrication point.
3. Wipe away any excess grease.
DIESEL FUEL
•
Use clean, quality No. 1-D or No. 2-D fuel
•
Use No. 1-D fuel if the ambient temperature
is expected to be lower than 4°C or if the
loader is to be used at an altitude exceeding
1524 m.
•
Use No. 1-2 diesel fuel with a pour point of at
least -12°C below the expected ambient
temperature to prevent fuel flow problems in
cold weather.
•
Keep dirt from entering the fuel tank.
•
Sulfur content of the fuel should be no more
than 0.5%.
•
Sediment and water content should not
exceed 0.05%.
•
Minimum cetane number is 40. Low
temperature or high altitude operation may
require use of fuel with a higher octane
number.
•
Use properly mixed winter fuel when
temperatures are extremely cold. In most
areas, diesel fuel is properly blended for
summer and winter grades as ambient
temperatures change. In winter, use winter
grade diesel fuel only. Otherwise, the fuel
may cloud and block the fuel system.
Ambient Temp (
ı
)
+5°-50°
-15°-50°
-25°-50°
-30°-15°
Recommended Oil
SAE 30W
SAE 15W-40
SAE 10W-30
SAE 5W-30
NOTE: CM Mower are originally shipped with
10W-30 oil.
Summary of Contents for CM314
Page 1: ...TRACTOR OPERATOR S MANUAL MODEL CM314 CM374 I H I GROUP IHI Shibaura Machinery Corporation...
Page 68: ...4 6 Wiring Diagram...
Page 73: ...4 13...
Page 74: ...4 14...
