10
3. Functions of monitor lamps
The pump is started by setting the main switch to the “Operation” position. When
the power switch is turned ON, all of the 3 lamps light up. If any one of the lamps
does not light up, the battery voltage is low or circuit has failed. Repair as required
in such a case. All of the lamps go out several seconds later.
At normal condition, all of the lamps are OFF while water is being discharged.
However, the lamps may light up when the self-starter motor is activated since the
battery voltage drops.
Monitor lamps keeping ON during pump operation or water discharge indicate
some trouble. Check and correct referring to the table below.
Indication
Meaning
Condition
Remedy
Fuel
Fuel
indicates
timing to
replenish the
fuel.
Lights up when the
remaining fuel in the fuel
tank decreases.
Replenish the regular
gasoline
2-cycle
engine oil
Indicates
timing to
replenish the
2-cycle
engine oil
Lights up when the
remaining 2-cycle engine
oil in the oil tank
decreases and stops the
engine.
Replenish the 2-cycle
engine oil (oil tank
capacity is about 1.4 L).
Radiator
Indicates
timing to
replenish the
engine
coolant.
Lights up when the
residual coolant in the
cylinder head decreases
and stops the engine.
Replenish the coolant
(about 600 mL)
Summary of Contents for FK500-A
