5A
For charging 12V 5Ah to 100Ah batteries
Maintenance for 12V 5Ah to 150Ah batteries
Suitable for charging lithium batteries
: LiFePO4
(do not charge other types of lithium
batteries)
12.5A
For charging 12V 70Ah to 250Ah batteries
Maintenance for 12V 70Ah to 360Ah batteries
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium
batteries)
25A
For charging 12V 150Ah to 550Ah batteries
Maintenance for 12V 150ah to 800Ah batteries
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium
batteries)
Lithium batteries are equipped with a BMS that in some cases can prevent the start of
the charging cycle; in this scenario to activate the charge process Press and hold the
“Function" button for 5 seconds, after setting the charger in lithium mode.
5A-12.5A-
25A
The
RECONDITION
mode is for WET and AGM batteries that have long been inactive and have an
acid stratification.
Caution:
due to the high voltage that is reached during this charging cycle,
recovery must be carried out with battery removed from the vehicle. A battery recovery connected
to the vehicle could cause damage to the on-board electronics. (Only in 12V mode)
After selecting the appropriate 12volt function the charging process starts automatically after 5 seconds.
For
24V batteries
the following charging parameters can be selected vi
a the “Function" button:
5A
For charging 24V 5Ah to 100Ah batteries
Maintenance for 24V 5Ah to 150Ah batteries
Suitable for charging WET and Gel batteries
12.5A
For charging 24V 70Ah to 250Ah batteries
Maintenance for 24V 70Ah to 360Ah batteries
Suitable for charging WET and Gel batteries
5A
For charging 24V 5Ah to 100Ah batteries
Maintenance for 24V 5Ah to 150Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB batteries
12.5A
For charging 24V 70Ah to 250Ah batteries
Maintenance for 24V 70Ah to 360Ah batteries
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB batteries
After selecting the appropriate 24volt function the charging process starts automatically after 5 seconds.
Additional battery charger functionallity can be selected using the mode button as follows.
SHOW
ROOM
SHOW ROOM
function: 13.8 V. This function keeps vehicle accessories in operation during
demonstrations in the dealership by supporting the connected vehicle battery. (Only in 12V mode)
SUPPLY
POWER SUPPLY
function: 14.0 V. Press and hold th
e “Mode " key for 5 sec to activate this function.
This function allows you to keep the memory of a vehicle active during battery changes or in all cases
where the battery is disconnected from the vehicle circuit. (Only in Mode 12V)
Warning: in this function the charger is not protected against reverse polarization.
RISK OF DAMAGE
!
