44 Shield T3 60 – 500KVA User Manual
3.
Table 3-3
Functions of Control and operation keys
Function Key
Description
EPO
Long press
，
cut off the load power (shut down the rectifier,
inverter, static bypass and battery)
BYP
Long press
，
transfer to the bypass(Push the button up in the
back of the door to enable , see Figure4.2)
INV
Long press, transfer to the inverter
MUTE
Long press to switch between turning off and on the buzzing
3.1.3
LCD touch Screen
Users can easily browse the information, operate the UPS, and set the parameters
through the LCD touchscreen, which is friendly for users.
After the monitoring system starts self-test, the system enters the home page,
following the welcome window. The home page is shown in
HT33200 N=01 (S)
11:03
Battery Not Connected-Set
…………………………
1 0
2 0
3 0
Status bar
……………………
……………………
……………………
…………………………
Information
Display
Warning
information
Main menu
Figure3-2
Home page
Home page consists of Status bar, Information display, warning information and main
menu.
Status bar
The Status bar contains the model of the product, capacity, operational mode, and the
number of the power module and the time of the system.
Warning Information
Display the warning information of the cabinet.
Information Display
Users can check the information of the cabinet in this area.
The bypass voltage, main input voltage, battery voltage, and output voltages are
presented in the form of gauge.
The loads are displayed in the form of bar chart in percentage. The green area stands
for a load of less than 60%, yellow area for a load of 60%-100% and red area for a load
of more than 100%.
The energy flow mimics the flow of the power.
