14
Installing / removing the battery
Installation of the battery
BT-E8010/BT-E6010
1.
Align the indentation in the bottom of the battery
with the protrusion on the holder and insert the
battery.
2.
Slide the battery to the right starting from the point
where it is inserted. Push in the battery until you hear
it click.
3.
Return the key to the locking position, remove it, and
store it in a safe place.
NOTE
•
Check to see that the battery is locked before riding the
bicycle. The battery may fall out while riding if not properly
locked in place.
•
Before riding, make sure that the charging port cap is
closed.
•
To prevent the battery from falling out, do not ride the
bicycle with the key inserted.
BT-E8020
For the purposes of demonstration, these instructions
take as an example a frame design where the battery is
removed/installed from below.
Insert the battery into the battery mount until there is a
click.
•
When inserted until a click is heard, the battery is
locked automatically.
NOTE
•
Check that the battery is locked before riding the bicycle.
The battery may come loose and fall out if not properly
locked in place before riding.
•
Before riding, make sure that the keyhole cap and charging
port cap are closed.
•
To prevent the battery from falling out, do not ride the
bicycle with the key inserted.
Keyhole cap
Summary of Contents for STEPS E8000 Series
Page 2: ......
