20
5.4.6. Bottom surface.
Carefully turn over your PLEXTALK and place it face down on the flat
surface, keeping the front of PLEXTALK towards you.
A little leftwards from the centre of the bottom surface, there are 3
raised ridges. These are at the right end of the battery cover. The
battery cover is fixed with the screw located at the lower left of the
battery cover. To open the battery cover, remove the screw at first.
Then put the thumb of your hand on the 3 ridges, to slide the battery
cover to the left only a little, and open the battery cover from the left
edge of the cover. It should release fairly easily without putting extra
pressure.
5.5. Inserting the battery.
In order to insert or replace the battery, do the following:
•
Turn off the power and remove the power adapter.
•
Carefully turn over your PLEXTALK and place it face down on
the flat surface, keeping the front of PLEXTALK towards you.
•
Open the battery cover, as described in the previous section,
and pick up the old battery using the projecting part, which is
on the left side of the battery.
•
Locate the new battery and orientate it so that the one edge,
which has five small holes, is facing to your right and the
projection is facing to the top.
•
Carefully place the battery into the battery slot vertically.
•
Close the battery cover and push it from the left side to the
right side to close tightly.
•
Fix the cover with the screw.
WARNING:
You should only use the recommended battery with this
unit. Failure to do so may cause an explosion or fire.
