15
Before you start
Before you start
Assembly
Assembly of the handle
Loop handle version
1.
Install the cushion into the handle as shown, fitting the tabs
into the corresponding holes on the handle.
2.
Insert the barrier bar into the clamp on the outer tube, mak-
ing sure the hole of the clamp is visible through the cutout on
the barrier bar.
3.
Position the handle forward of the Handle positioning label
at the best position for operator comfort. Push down hard to
pop handle housing over outer tube.
4.
Install square nut in handle and use bolt to fasten and tight-
en against handle.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
CAUTION
Install the handle so that it does not hide any of the safety decals.
1. Cushion
2. Projection tab
NOTE
Keep handle forward of handle positioning label!
1. Handle
2. Square nut
3. Barrier bar
4. Bolt
5. Cushion
6. Clamp
7. Outer tube
1. Arrow point
IMPORTANT
Make sure the arrow on the handle point towards gear case.
Summary of Contents for C310S
