23
9. Operating Procedures
9-1. Initial Startup/Pre-Check
WARNING : EXHAUST GAS POISONING
Do not operate the generator in poorly ventilated areas such as an indoors or
tunnels, as the exhaust gas of the engine contains substances that are
harmful to human health.
Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
Always be sure to check that the breakers on load side and switches for any
equipment using the generator are at OFF before turning the breaker to ON.
Also be sure to advise personnel on the load side that power will be turned
on before operating the breaker.
Close all doors and lock them during operation.
CAUTION : FIRE
Do not bring flammable items (such as fuel, gas and paint) or items that are
highly combustible near the generator as the muffler, exhaust gas and other
parts become extremely hot.
Position this generator 1 m or more from walls or other hindrances, and on
a level surface.
CAUTION : INJURY
Do not operate the generator if it has been modified or any parts have been
removed.
Position the generator on a level stable surface so that it cannot slide or
move in any manner.
Before starting operation, always be sure to turn off all switches of equipment
being used and all breakers to OFF.
< Note >
Check that the surrounding area is safe before starting the engine.
When there are multiple workers who are working together, they must mutually signal each other
before starting the engine.
Do not use in an area with high temperature or humidity, or an area with a large amount of dust.
Do not open any doors during operation. Operating with door open can negatively affect cooling
effect, resulting in an equipment malfunction.
Use ear protection if the level of noise is high. Failure to do so could result in hearing damage.
Please be careful about a strong wind and the opening and shutting of the door at the sloping
place enough. A door is open suddenly and is closed, and a finger might be sandwiched.
Turn the main breaker on
the operation panel to OFF.
Turn the Throttle switch to IDLING.
Turn the Battery Isolator to ON position
Turn the Starter switch to PREHEAT.
When the pre-heating indicator changes
from lit up to off, immediately change the
switch to START and start the engine.
5
1
4
2
3
Throttle Switch
Starter
Switch
MainBreaker
Pre-Heating
Indicator
Battery isolator
Summary of Contents for DG50MK-P
