6
CAUTION!
Some gasolines contain alcohol as
an oxygenate! Oxygenated fuels
may cause increased operating
temperatures. Under certain condi-
tions, alcohol-based fuels may also
reduce the lubricating qualities of
some mixing oils. Never use any
fuel containing more than 10%
alcohol by volume!
Generic oils and some outboard
motor oils may not be intended for
use in high-performance air cooled
2-cycle engines, and should never
be used in your Shindaiwa engine!
CAUTION!
This engine is designed to operate
on a 50:1 mixture consisting of
unleaded gasoline and a Premium
2-cycle mixing oil only. Use of Non-
approved mixing oils can lead to
excessive maintenance costs and/or
engine damage.
IMPORTANT!
Mix only enough fuel for your immedi-
ate needs! If fuel must be stored longer
than 30 days and Shindaiwa One oil
with fuel stabilizer is not used, it should
first be treated with a fuel stabilizer
such as StaBil™.
WARNING!
Minimize the risk of fire!
■
Stop the engine before
refueling.
■
Always allow the unit to cool
before refueling!
■
Wipe all spilled fuel and move
the unit at least 10 feet
(3 meters) from the fueling
point before restarting!
■
Never smoke or light any fires
near the unit or fuels!
■
Never place any flammable
material near the engine muffler!
■
Never operate the engine without
the muffler and spark arrester in
place and properly functioning!
■
Never
operate this blower if fuel
system components are dam-
aged or are leaking!
24006
Filling the Fuel Tank
1. Place the blower upright on the
ground or on a sturdy work surface,
and wipe any debris from around the
fuel cap.
2. Remove the fuel cap.
3. Fill the tank with a clean, fresh
fuel mixture.
4. Replace the cap, and wipe away any
spilled fuel before starting the
blower.
Remove the Fuel
Filler Cap
Mixing Fuel
■
Use only fresh, clean unleaded
gasoline with a pump octane rating of
87 or higher.
■
Mix gasoline with 50:1 Shindaiwa
Premium 2-cycle mixing oil or with
an equivalent high quality 2-cycle
mixing oil.
Example of 50:1 mixing quantites:
■
1 gallon of gasoline to 2.6 oz. mixing
oil.
■
5 litres of gasoline to 100 ml. mixing
oil.
English
6
¡IMPORTANTE!
Mezcle solamente el combustible
necesario para uso inmediato. Si el
combustible debe ser almacenado por
más de 30 días y no se ha utilizado
aceite Shindaiwa One con estabilizador
de combustible, el mismo deberá ser
primero tratado con un estabilizador de
combustible tal como StaBil™.
¡ADVERTENCIA!
Disminuya el riesgo de
incendios.
■
Pare el motor antes de volver a
llenar el tanque.
■
Siempre permita que el equipo se
enfríe antes de cargar combus-
tible.
■
Limpie todo el combustible
derramado y aleje el equipo por
lo menos 3 metros (10 pies) del
sector de llenado de combustible
¡antes de volver a arrancarlo!
■
Nunca fume o encienda fuego
cerca del equipo o los
combustibles.
■
Nunca coloque materiales
inflamables cerca del silenciador
del motor.
■
Nunca opere el motor sin el
silenciador y el amortiguador de
chispas en su posición correcta y
funcionando adecuadamente.
■
Nunca
opere este soplador si hay
componentes del sistema de
combustible dañados o
con fugas.
Llenado del tanque de combustible
1.
Coloque el soplador verticalmente
sobre el suelo o sobre una superficie
de trabajo firme y limpie cualquier
residuo que hubiera en torno de la
tapa de combustible.
2.
Quite la tapa de combustible.
3.
Llene el tanque con una mezcla
limpia y fresca de combustible.
4.
Antes de arrancar el soplador,
reponga la tapa y limpie el combus-
tible derramado.
Quite la tapa del
surtidor de
combustible
24006
Español
Summary of Contents for EB240S
