Shindaiwa LE230, Owner'S/Operator'S Manual

7

Ground Wire 

Terminal

Ground 

Wire

Assembly

Throttle Linkage and Ignition Leads

 (continued)

Assemble and Adjust  

the Throttle Cable.

1.  Insert the throttle-cable housing into the 

notch on the fan cover, and clamp the 

ground wire terminal between the fan 

cover and the outer cable adjuster nut.              

See Figure 10.

2.  Tighten the two throttle cable adjuster 

nuts.

   IMPORTANT! 

Adjust and tighten the cable nuts to allow 

approximately 1/4-inch free play at the 

throttle trigger.

CAUTION! 

Routing of wiring must not interfere with 

throttle operation.

Figure 10

Reinstall the Spark 

Plug Cap

Black  Ignition 

Wire

Red Wire

Cable  Adjuster 

Nuts

3.  Using finger pressure only, connect 

the black ignition wire from the cable 

tube to the red ignition wire on the 

powerhead. Wire routing must be as 

shown in the illustration with the black 

wire located away from the throttle cable 

and carburetor linkage.

4.  Reinstall the engine cover and tighten 

the captive engine cover screw. 

5.  Reinstall the spark plug boot.

23028

Assembly

Handle

1.  Remove both screws from the handle.
2.  While spreading the handle at the 

mounting hole, position the handle on 

the outer tube as shown.

3.  Reinstall the two mounting screws in the 

handle, but do not tighten them at this 

time. 

NOTE:

The handle is recessed to receive the hex nuts.

4.  Locate the handle at the best position 

for operator comfort (usually about 10 

inches ahead of the throttle assembly).

5.  Secure the handle by tightening the 

mounting screw and the adjustment 

knob screw.

Handle

Hex Nut

Washer

Hex Nut

Outer Tube

Adjustment 

Knob

Mounting Screw

Washer

Connect the Handle to the  

Outer Tube.

Figure 11

Throttle  

Assembly

Ignition 

Switch