SAFETY
LE262
12
X7502341501
© 03/2019 ECHO Inc.
Equipment
Use only Shindaiwa attachments. Serious injury may result from
the use of a non-approved attachment combination. ECHO, INC.
will not be responsible for the failure of cutting devices,
attachments or accessories which have not been tested and
approved by ECHO. Read and comply with all safety
instructions listed in this manual and safety manual.
◆
Check unit for loose/missing nuts, bolts, and screws.
Tighten and/or replace as needed.
◆
Inspect shield for damage and that shield is securely in
place. Replace if shield is damaged or missing.
◆
Check that the cutting attachment is firmly attached and in
safe operating condition.
◆
Check that support handle is adjusted for safe,
comfortable operation. See Assembly Section for proper
adjustment.
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
◆
ALWAYS stop engine, disconnect spark plug, and make
sure all moving parts have come to a complete stop before
removing obstructions, clearing debris, or servicing unit.
◆
DO NOT start or operate unit unless all guards and
protective covers are properly assembled to unit.
◆
NEVER reach into any opening while the engine is running.
Moving parts may not be visible through openings.
Periodically Check fuel system (fuel lines, vent, grommet, fuel
tank, and fuel cap) for leaks especially if the unit is dropped. If
damage or leaks are found, do not use unit, otherwise serious
personal injury or property damage may occur. Have unit
repaired by an authorized servicing dealer before using.
