Engine Cover
Screws
Engine Cover
0XIÀHU
0XIÀHU*DVNHW
0XIÀHU%ROWV
Spark Arrester Screen
Spark Arrester Cover
Cover Screws
With a 3 mm hex wrench remove the
1.
4 engine cover screws and the engine
cover.
14
Whenever the unit will not be used for 30
days or longer, use the following proce-
dures to prepare it for storage:
Clean external parts thoroughly.
Ŷ
Drain all the fuel from the carburetor
Ŷ
and the fuel tank.
Long Term Storage
Remove remaining fuel from the fuel
Ŷ
lines and carburetor with the fuel
drained from the fuel tank. To do so:
Prime the primer bulb until no more
1.
fuel is passing through.
Start and run the engine until it stops
2.
running.
Repeat steps 1 and 2 until the engine
3.
will no longer start.
Remove the spark plug and pour about
Ŷ
7 mL (¼ oz.) of 2-cycle mixing oil into
the cylinder through the spark plug
hole. Slowly pull the recoil starter 2 or 3
times so oil will evenly coat the interior
of the engine. Reinstall the spark plug.
CAUTION!
Gasoline stored in the carburetor for
extended periods can cause hard start-
ing, and could also lead to increased
service and maintenance costs.
Before storing the unit, repair or
Ŷ
replace any worn or damaged parts.
Remove the air cleaner element from
Ŷ
the carburetor and clean it thoroughly
with soap and water, let dry and reas-
semble the element.
Store the unit in a clean, dust-free area.
Ŷ
If the engine becomes sluggish and low
on power, check and clean the spark
arrester screen.
IMPORTANT!
If you note excessive carbon buildup, con-
sult with an authorized Shindaiwa servic-
ing dealer.
Maintenance
(continued)
0XIÁHU0DLQWHQDQFH
WARNING!
Never operate the unit with
DGDPDJHRUPLVVLQJPXIÀHURUVSDUN
arrester! Operating with a missing or
GDPDJHGVSDUNDUUHVWHULVD¿UHKD]DUG
and could also damage your hearing.
With a 4 mm hex wrench, remove the
2.
3 muffler bolts and the muffler.
With a small flat bladed screwdriver
3.
remove the 2 screws holding the
spark arrester screen and cover to the
muffler.
Remove the screen and clean it with a
4.
stiff bristle brush.
Inspect the cylinder exhaust port for
5.
any carbon buildup.
Reassemble the spark arrester, muf-
6.
fler and engine cover in the reverse
order of disassembly.
IMPORTANT!
All stored fuels should be stabilized with a
fuel stabilizer such as STA-BIL, if
oil
with fuel stabilizer is not used.
Summary of Contents for M2510/EVC
Page 19: ...21 NOTES NOTAs REMARQUES...
Page 39: ...SP_21 Espa ol NOTES NOTAs REMARQUES...
